Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs

Research output: Chapter in Book/Report/Conference proceedingConference contribution

1 Citation (Scopus)

Abstract

The effects of the design and operating parameters, namely the bearing parameter (B), gravity parameter (W) and mass ratio (α), on the bifurcations in the response of a flexible rotor supported by squeeze-film dampers without centering springs were examined using direct numerical integration. Specifically, the effects of these parameters on the onset speed of bifurcation and the extent of non-synchronous response within the range of speed parameter (Ω) between 0.5 and 5.0 were determined. The results showed that increasing B resulted in the increase of the onset speed of bifurcation, and a decrease in the range of Ω where non-synchronous response was observed. With the exception of the case of W=0.0, the increase of W was found to increase the onset speed of bifurcation and also the range of Q where non-synchronous response was observed. The effect of increasing a resulted in a decrease in the range of Ω where non-synchronous response existed. The increase of a also caused the onset speed of bifurcation to increase, except for the case of B =0.05, W =0.0, where the onset speed of bifurcation was observed to decrease as α was increased. The numerical results presented in this work were obtained for an unbalance parameter (U) of 0.1, which is considered to be at the upper end of the acceptable range of balance quality specifications for practical rotor systems.

Original languageEnglish
Title of host publicationProceedings of the Tenth International Congress on Sound and Vibration
EditorsA. Nilson, H. Boden
Pages1611-1618
Number of pages8
Publication statusPublished - 2003
EventProceedings of the Tenth International Congress on Sound and Vibration - Stockholm, Sweden
Duration: 07 Jul 200310 Jul 2003

Other

OtherProceedings of the Tenth International Congress on Sound and Vibration
CountrySweden
CityStockholm
Period07/07/0310/07/03

Fingerprint

Rotors
Bearings (structural)
Gravitation
Specifications

All Science Journal Classification (ASJC) codes

  • Engineering(all)

Cite this

Inayat Hussain, J. I. (2003). Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs. In A. Nilson, & H. Boden (Eds.), Proceedings of the Tenth International Congress on Sound and Vibration (pp. 1611-1618)
Inayat Hussain, Jawaid Iqbal. / Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs. Proceedings of the Tenth International Congress on Sound and Vibration. editor / A. Nilson ; H. Boden. 2003. pp. 1611-1618
@inproceedings{f331c2ba2dd043bfa18d6f13f8167f10,
title = "Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs",
abstract = "The effects of the design and operating parameters, namely the bearing parameter (B), gravity parameter (W) and mass ratio (α), on the bifurcations in the response of a flexible rotor supported by squeeze-film dampers without centering springs were examined using direct numerical integration. Specifically, the effects of these parameters on the onset speed of bifurcation and the extent of non-synchronous response within the range of speed parameter (Ω) between 0.5 and 5.0 were determined. The results showed that increasing B resulted in the increase of the onset speed of bifurcation, and a decrease in the range of Ω where non-synchronous response was observed. With the exception of the case of W=0.0, the increase of W was found to increase the onset speed of bifurcation and also the range of Q where non-synchronous response was observed. The effect of increasing a resulted in a decrease in the range of Ω where non-synchronous response existed. The increase of a also caused the onset speed of bifurcation to increase, except for the case of B =0.05, W =0.0, where the onset speed of bifurcation was observed to decrease as α was increased. The numerical results presented in this work were obtained for an unbalance parameter (U) of 0.1, which is considered to be at the upper end of the acceptable range of balance quality specifications for practical rotor systems.",
author = "{Inayat Hussain}, {Jawaid Iqbal}",
year = "2003",
language = "English",
pages = "1611--1618",
editor = "A. Nilson and H. Boden",
booktitle = "Proceedings of the Tenth International Congress on Sound and Vibration",

}

Inayat Hussain, JI 2003, Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs. in A Nilson & H Boden (eds), Proceedings of the Tenth International Congress on Sound and Vibration. pp. 1611-1618, Proceedings of the Tenth International Congress on Sound and Vibration, Stockholm, Sweden, 07/07/03.

Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs. / Inayat Hussain, Jawaid Iqbal.

Proceedings of the Tenth International Congress on Sound and Vibration. ed. / A. Nilson; H. Boden. 2003. p. 1611-1618.

Research output: Chapter in Book/Report/Conference proceedingConference contribution

TY - GEN

T1 - Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs

AU - Inayat Hussain, Jawaid Iqbal

PY - 2003

Y1 - 2003

N2 - The effects of the design and operating parameters, namely the bearing parameter (B), gravity parameter (W) and mass ratio (α), on the bifurcations in the response of a flexible rotor supported by squeeze-film dampers without centering springs were examined using direct numerical integration. Specifically, the effects of these parameters on the onset speed of bifurcation and the extent of non-synchronous response within the range of speed parameter (Ω) between 0.5 and 5.0 were determined. The results showed that increasing B resulted in the increase of the onset speed of bifurcation, and a decrease in the range of Ω where non-synchronous response was observed. With the exception of the case of W=0.0, the increase of W was found to increase the onset speed of bifurcation and also the range of Q where non-synchronous response was observed. The effect of increasing a resulted in a decrease in the range of Ω where non-synchronous response existed. The increase of a also caused the onset speed of bifurcation to increase, except for the case of B =0.05, W =0.0, where the onset speed of bifurcation was observed to decrease as α was increased. The numerical results presented in this work were obtained for an unbalance parameter (U) of 0.1, which is considered to be at the upper end of the acceptable range of balance quality specifications for practical rotor systems.

AB - The effects of the design and operating parameters, namely the bearing parameter (B), gravity parameter (W) and mass ratio (α), on the bifurcations in the response of a flexible rotor supported by squeeze-film dampers without centering springs were examined using direct numerical integration. Specifically, the effects of these parameters on the onset speed of bifurcation and the extent of non-synchronous response within the range of speed parameter (Ω) between 0.5 and 5.0 were determined. The results showed that increasing B resulted in the increase of the onset speed of bifurcation, and a decrease in the range of Ω where non-synchronous response was observed. With the exception of the case of W=0.0, the increase of W was found to increase the onset speed of bifurcation and also the range of Q where non-synchronous response was observed. The effect of increasing a resulted in a decrease in the range of Ω where non-synchronous response existed. The increase of a also caused the onset speed of bifurcation to increase, except for the case of B =0.05, W =0.0, where the onset speed of bifurcation was observed to decrease as α was increased. The numerical results presented in this work were obtained for an unbalance parameter (U) of 0.1, which is considered to be at the upper end of the acceptable range of balance quality specifications for practical rotor systems.

UR - http://www.scopus.com/inward/record.url?scp=2342437525&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=2342437525&partnerID=8YFLogxK

M3 - Conference contribution

AN - SCOPUS:2342437525

SP - 1611

EP - 1618

BT - Proceedings of the Tenth International Congress on Sound and Vibration

A2 - Nilson, A.

A2 - Boden, H.

ER -

Inayat Hussain JI. Effects of system parameters on the bifurcations of a flexible rotor response in squeeze-film dampers without centering springs. In Nilson A, Boden H, editors, Proceedings of the Tenth International Congress on Sound and Vibration. 2003. p. 1611-1618