Design and implementation of a direct torque control of induction machine utilizing a digital signal processor and the field programmable gate arrays

Chuen Ling Toh, N. R.N. Idris, A. H.M. Yatim, Fazlli Patkar

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Abstract

Employing both DSP and FPGA in motion control will give advantages of rapid prototyping and higher switching frequency in Direct Torque Control (DTC) drive. This paper presents a high performance DTC induction motor drive with constant switching frequency and low torque and flux ripples. The experimental results prove the feasibility of the proposed controllers, which is achieved using the combination of a DSP and an FPGA.

Original languageEnglish
Title of host publicationProceedings of the International Conference on Power Electronics and Drive Systems
Pages72-77
Number of pages6
Publication statusPublished - 01 Dec 2005
EventSixth International Conference on Power Electronics and Drive Systems, PEDS 200 - Kuala Lumpur, Malaysia
Duration: 28 Nov 200501 Dec 2005

Publication series

NameProceedings of the International Conference on Power Electronics and Drive Systems
Volume1

Other

OtherSixth International Conference on Power Electronics and Drive Systems, PEDS 200
CountryMalaysia
CityKuala Lumpur
Period28/11/0501/12/05

    Fingerprint

All Science Journal Classification (ASJC) codes

  • Electrical and Electronic Engineering

Cite this

Toh, C. L., Idris, N. R. N., Yatim, A. H. M., & Patkar, F. (2005). Design and implementation of a direct torque control of induction machine utilizing a digital signal processor and the field programmable gate arrays. In Proceedings of the International Conference on Power Electronics and Drive Systems (pp. 72-77). [1619663] (Proceedings of the International Conference on Power Electronics and Drive Systems; Vol. 1).